Comments for Electronics For You

Comment on Wearable Automatic Assistance Glove by Pradeep Hooda

Pradeep Hooda — Wed, 06 Nov 2024 09:54:54 +0000

Please Check Details and Circuit diagram before publish article, because in this project you circuit diagram is incomplete there is no connection between Arduino pin and RF-Decoder IC. In receiver circuit diagram also you mention wrong fig. number for Transmission Circuit in Circuit and Working Section. please check it and publish again.
Thankyou

Comment on IoT based Entry and Exit Monitoring System by Ashwini Sinha

Ashwini Sinha — Mon, 28 Oct 2024 06:18:24 +0000

In reply to vijayalakshmi kakarla. When you scan the RFID at entry gate it logged in to the webserver hosted by the IndusBaord Coin and when you scan again at the gate for exit it detect the same UUID card number and logedout and update it on webserver. For video we will try to do one live session in upcomming month.

Comment on IoT based Entry and Exit Monitoring System by vijayalakshmi kakarla

vijayalakshmi kakarla — Sun, 27 Oct 2024 07:39:45 +0000

Sir please provide me video regarding this project I want to know how it works please reply me

Comment on Coal Mining Safety Robot Using Arduino by EFY Bureau

EFY Bureau — Fri, 25 Oct 2024 05:04:24 +0000

In reply to Sudarshan8045. The source code is present at the end of the article.

Comment on Smallest Digital FM Radio Receiver by Nishith Verma

Nishith Verma — Fri, 25 Oct 2024 03:11:12 +0000

Hi, What is the use of posting screen shot of the code which is not complete? Regards.

Comment on Coal Mining Safety Robot Using Arduino by Sudarshan8045

Sudarshan8045 — Wed, 23 Oct 2024 03:37:44 +0000

Where can we find the full code for this project?

Comment on Low-cost Touch Switchboard Circuit Design by K SRIRAM AMARNADH

K SRIRAM AMARNADH — Sat, 19 Oct 2024 03:35:26 +0000

and also pcb layout in dip trace with geber file extract pls provide sir

Comment on Low-cost Touch Switchboard Circuit Design by K SRIRAM AMARNADH

K SRIRAM AMARNADH — Sat, 19 Oct 2024 03:33:24 +0000

pls me provide the schematic design of the circuit in dip trace i am tried but i not made done

Comment on Thermal Management System For Electric Vehicles by Kaviya Sri V

Kaviya Sri V — Thu, 17 Oct 2024 10:44:12 +0000

Can you share this project simulation circuit in private??

Comment on 3W/6W audio amplifier using TDA2003 by Suresh Dwivedi

Suresh Dwivedi — Mon, 14 Oct 2024 06:34:30 +0000

The TDA2003 is designed to operate within a voltage range of 8-18V DC, so running it at 5V may result in significantly reduced output or it may not work at all.

Regarding wiring speakers in parallel:
If you wire your 8-ohm speakers in parallel, the resulting load will be 4 ohms. The TDA2003 can handle a 4-ohm load, but you should ensure that the output power does not exceed the speakers’ rated capacity to avoid damaging them.